Arpeggiator Sync
Allows the Arpeggiator to be synchronized with an external
sequencer. A range of synchronization values are available is
shown in the table below.
When a sync interval is selected, the tempo of the Arpeggiator
is controlled by the Arpeggiator Rate setting (page 36) when
MIDI Clock Source is set to i - internal - or by the external
sequencer’s tempo when MIDI Clock Source is set to e - exter-
nal - See Page 52 for information on setting the Global MIDI
Clock Source.
Arpeggiator Destination
For flexibility, the Arpeggiator output may be routed to a number
of destinations. Setting the Arp destination to In ( Internal)
routes the Arpeggiated notes to the internal sound engine. This
could be considered as the normal mode of operation. There
will be no Arpeggiated notes output from the MIDI out socket
using this setting.
Setting the destination to Et (external) will route the
Arpgeggiated notes ONLY to the MIDI output socket. Please
note: There will be no sound from the A-Station rack's own
sound engine when this option is selected.
Setting the destination to IE (internal and external) will route
Arpgeggiated notes to both the MIDI output socket and the
internal sound engine.
Setting the destination to EP (External and Played) will route
the Arpeggiated notes to the MIDI output socket but in addition
the A-Station sound engine will just play the notes as received
(not arpeggiated) from an external MIDI keyboard or controller
device.
38
Arpeggiator
Advanced features
To Next Page
Loading...
