Chapter5 Using of software
Manual of NVEC400
- 34 -
one or more workpiece coordinate system.
、
1 Move to current working piece 0 point
Firstly hold down the material,use keyboard or pendant to move tool tip at the 0 point,so this
0 point is the working piece 0 point,it related with the working G code file,so the user must be very
familiar to his own working G code.As our example shows,the 0 point is on the center of the
working piece surface,so we just move the tool tip to this position.
、
2 clear Coordinate
As 5-5 shows,press Zero button on each axis, then clear to 0 for each axis.After operation,the
result shows as Figure 5-6.
Figure5-5. Press Zero on each axis,all clear to 0
www.nvcnc.net
To Next Page
Loading...
Need help?
General