Chapter5 Using of software
Manual of NVEC400
- 33 -
As Figure 5-3 shows,this page also can set machine soft limit points,Soft Max is positive
direction soft limited points,soft Min is negative direction soft limited points.The soft limited
points values is according the references to the machine coordinate system,so as this example
shows,Y and Z axis’s max value is 0,all the effective coordinate data is less than 0.As the Figure
shows,according to our current request,we set our XYZ axis soft limited points area as [0,270]
[-390,0] [-100,0].
、
3 Searching for machine original points
Figure5-4. Click REF ALL HOME to HOME all axis
As Figure 5-4 shows,press REF ALL HOME at main display page,then XYZ A4 start to
search for the original points,if you need more axis’s operation,edit macro command,or press
Alt+7 into Diagnostics display page,you can search original point for every axis. Diagnostics
5.2 Set workpiece coordinate system
Because every working material is hold in different position on the machine,we need to set
www.nvcnc.net
To Next Page
Loading...
Need help?
General