Chapter1 Introduction
Manual of NVEC400
- 3 -
Figure1-2. The other side of NVEC400and installation dimensions
1.4 substantival explanation
When operate the NVEC400, where will be a lot of English abbreviation, now we list all of
them for your kindly references:
FRO: Feeding adjust: During the operating process, the F value already set, and need to
adjust the current feeding speed, then we can adjust FRO value to realize it.
SRO: Spindle speed adjust: During the operating process, the S value already set, and need
to adjust the current spindle speed, then we can adjust SRO value to realize it :
Current Speed S#=setting S*SRO.
www.nvcnc.net
To Next Page
Loading...
Need help?
General