– 78 –
Extraction control
Switch on/lift extraction tower position
Decrease extraction speed
Increase extraction speed
Switch off/lower extraction tower position
Extraction indication
Cleaning indication for grease filter
Replacement indicator Monoblock filter (optional)
Preset extraction function
Locking the extraction tower
Hob control
Switch hob on/off
Select cooking zone
Increase power level
Reduce power level
Power level indication
OVERVIEW OF THE FUNCTIONS NOVY PANORAMA POWER
Switch hob on/off
ON - Press and hold for 2 seconds.
Cooking zones display lights up.
OFF - Press . Cooking zones display extinguishes.
Switching a cooking zone on and off
ON - Press the cooking zone selection button
OFF - Press the cooking zone selection button and [–] simultaneously
until the display shows [0] or [H] = “Hot”.
Switching Power on and off
ON - Press cooking zone selection button
Press the [–] button and then the [+] button until [P]
OFF - Press the [–] button.
Power limit
Selected cooking zone with Power function [P]
Power limit activated
[9] is reduced to [8] and flashes [8].
Timer function
Press [–] and [+] at the same time.
Reduce the time
Press [–]
Increase the time
Press [+]
Switch off the timer function
Press the cooking zone selection button.
Press [+] and [–] at the same time.
Stop the timer
Pr
ess [–] until timer is set to [00].
Using the timer without cooking
Switch on the hob. Press [–] and [+] for 2 seconds.
Select the timer
Press [–] and [+] at the same time.
Reduce the time
Press [–] on the timer.
Increase the time
Press [+] of the timer.
Operate bridge function manually
ON - Simultaneously press the 2 cooking zone selection buttons
.
OFF - Simultaneously press the 2 activated cooking zone selection
buttons
.
Increase the power
Press [–] or [+] button.
Locking the controller
1. Switch the hob on using the
button.
2. Press the [–] and
buttons of the right front zone
simultaneously.
3. Press the
button of the right-front zone again.
Unlocking the controls
1. Switch the hob on using the
button.
2. Press the [–] and
buttons of the right front zone simultaneously.
3. Press the [–] button again.
Switch extraction hood on
POSITION 10 cm: Briefly press
POSITION 30 cm: For 2 seconds, press
Change extraction hood position
HIGHER - Press
LOWER - Press
Extraction hood - Run-out function/Switch off
RUN-OUT FUNCTION: For 2 seconds, press
. The extraction
tower will shut off automatically after 10/30 minutes
SWITCH OFF: press
Preset extraction function AUTO (20cm)
Press
Locking the extraction tower
ON/OFF - For 3 seconds, press
To Next Page
Loading...
