Nowy Styl eUP - Desk Operation and Adjustment; First Start-up Procedure; Desk Height Adjustment

4
EN
eUP2
First start-up / restart of the desk
To ensure correct desk operation the base needs to be started up before first use
 Press and hold buttons “down” and “up” at the same time for more than  seconds
until the desk stops
— Note: The desk will move downwards to the lowest position, then it will move
upwards by about 2-5 mm and then it will stop.
 When the desk has stopped release the “down” and “up” buttons The initial set-up
process is now completed and the desk is ready for operation
The first start-up procedure should be performed after desk installation
or after apart of the desk has been replaced.
Desk height adjustment
To decrease desk height
 Press and hold the “down” button until the desired height is reached
To increase desk height
 Press and hold the “up” button until the desired height is reached