Nowy Styl eUP - Saving Height Settings; Comparing Display Data

5
EN
eUP3
First start-up / restart of the desk
To ensure correct operation the desk needs to be started up before first use
 Press and hold buttons “down” and “up” at the same time for more than  seconds until
the desk stops
— Note: The desk will move downwards to the lowest position, then it will move upwards
by about 2 – 5 mm and then it will stop.
 When the desk has stopped release the “down” and “up” buttons The initial set-up process
is now completed and the desk is ready for operation
The first start-up procedure should be performed after desk installation
or after apart of the desk has been replaced.
Desk height adjustment
To decrease desk height
 Press and hold the “down” button until the desired height is reached
To increase desk height
 Press and hold the “up” button until the desired height is reached
Saving height settings:
 Use the “up” and “down” buttons to set the desired desk height – the height will be shown
on the display
To save multiple heights:
 Press the “S” button
— When the display starts flashing, you have 6 seconds to press one of the buttons 1, 2 or 3
to save the current desk position to aselected number.
Comparing data from the display with the actual height
Position your desk at any height the lowest possible position is recommended
Measure the actual desk height and make anote of the result in centimetres or inches
If the actual height is different from the height on the display
 Press and hold the “S” button while also pressing and holding the “up” button and wait
approx  seconds
— The first digit will start flashing.
 Release both buttons and press the “up” or “down” button to change the first digit
— Increase or decrease the first digit to reach the measured value.
 Press the “S” button
— The second digit will start flashing.
1 2 3 S