Nowy Styl eUP - Setting Display Units; Additional Control Panel Features

6
EN
eUP3
 Press the “up” or “down” button to change digit value
— Increase or decrease the second digit to reach the measured value.
 Press the “S” button
— The third digit will start flashing.
 Press the “up” or “down” button to change digit value
— Increase or decrease the third digit to reach the measured value.
 Press the “S” button The settings have been saved
Setting display units to centimetres or inches
 Press and hold the “S” button for  seconds and then press and hold the “up” button for
approx  seconds
— The height unit will be changed from CM to INCHES or vice versa.
 Release the buttons The settings have been saved
ADDITIONAL CONTROL PANEL FEATURES
Setting the desk to stop at adesired lowest position
(e.g. cabinet or pedestal under the desk)
 Set the desired desk height by pressing the “up” or “down” button
 Press and hold the “S” button and then press and hold the “1” button for approx  seconds
until the symbol “_L_” is shown on the display
— The symbol “_L_” will be shown on the display. This means that the lowest desk position
has been saved.
 Release the buttons The settings have been saved
Setting the desk to stop at adesired highest position (e.g. window sill)
 Set the desired desk height by pressing the “up” or “down” button
 Press and hold the “S” button and then press and hold the “3” button for approx  seconds
until the symbol “_L_” is shown on the display
— The symbol “_L_” will be shown on the display. This means that the highest desk position
has been saved.
 Release the buttons The settings have been saved
1. Desk height can now be adjusted within alimited range, between the preset positions.
2. Any previously saved heights beyond the maximum and minimum height positions
will be lost.