8 9
INITIAL RUN
Touch the “Purifi ed Water” button. The LED light will show orange.
Turn on the water faucet.
Let the water run through the water purifi er until the water is clear to
prepare the 3in1 cartridge for normal use. The LED light will change to
blue once the water purifi er is ready for use.
Letting the water run until clear cleans the 3in1 cartridge and its
tubing. Water will initially come out greyish-black or soapy. This is normal.
USE
The faucet attachment has two outlets—one for tap water and the
other for Purifi ed Water.
Tap water
Purifi ed Water
PURIFIED WATER
Touch the “Purifi ed Water” button. A blue LED light will indicate
your selection.
Turn on the faucet to dispense Purifi ed Water.
• The water purifi er will switch to tap water if water temperature is over 38˚C
to protect the life cycle of the 3in1 cartridge.
• Water fl ow will reduce if the purifi er is run in conjunction with lower water
temperature and pressure. If LED light shows orange, let the water run
through the water purifi er until the LED light changes to blue.
• The device will automatically switch to tap water mode if the faucet is
turned o for more than 10 seconds.
TAP WATER
Touch the “Tap Water” button to switch to tap water.
You can alternate between tap water and Purifi ed Water mode by
pressing either button.
When using “Tap Water” mode, water temperature is irrelevant.
REPLACING in CARTRIDGE
When the 3in1 light indicator starts fl ashing orange, it means that the 3in1
cartridge will need to be replaced soon.
When the 3in1 and Purifi ed Water light indicators remain orange, it is time
to replace the 3in1 cartridge.
PURCHASING in CARTRIDGES
There are two ways to purchase replacement 3in1 cartridges:
• Order online at www.nuskin.com
• Purchase at your local Nu Skin Distributor Center
+
+
94507300-3_ecosphere_water_purifier_user_manual_without_WiFi_smaller_version.indd 8-9 3/7/19 3:30 PM
To Next Page
Loading...
