Nuga E5 - Page 11

 How to Use Product
E5
Separate the power cord from
the power outlet after use.
Set the output by pressing the
channel 1 low frequency output
FRQWUROEXWWRQµŸ¶µź¶
A level is displayed on the low
frequency display unit (FND) of the
channel 1 (CH1).
The level can be adjusted between
1 and 20.
TUFQ
Set the channel 1 low frequency
mode by pressing the channel 1
start/stop button (CH1) of the
controlling unit.
TUFQ
Press the channel 1 start/stop
button (CH1) to finish the
operation while operating.
It is automatically stopped
in the set time (30 minutes)
TUFQ
TUFQ
Notice
i
HEAT
M1 M2
LH
M
L F
AUTO
TIME
CH1 CH2
HEAT
M1 M2
LH
M
L F
AUTO
TIME
CH1 CH2
HEAT
M1 M2
LH
M
L F
AUTO
TIME
CH1 CH2
CH1
CH1
Caution
Press the start/stop button to
ILQLVKWKHRSHUDWLRQWXUQRIIWKH
SRZHUVZLWFKDQGVHSDUDWHWKH
power cord from the power
outlet.
All the cords should be
separated while moving the
SURGXFW2WKHUZLVHLWPD\FDXVH
the damage of the product.
It may cause an error if the
product is turned on when the
product is not used.