How to Use Product
E5
TUFQ
Adjust the intensity of
low frequency by pressing
‘-’,‘+’ of the controller.
TUFQ
Press the low frequency
start/stop button once more to
finish the operation.
How to Use Controller
- Low frequency
Introduction
·Do not use it for other usages than the described purposes of uses.
·Check out the working voltage before use.
·Point the controller only towards the controller receive sensor when operating.
i
TUFQ
Connect the power cord to
the back side of the product,
and connect it to the power
outlet.
Check out the working
voltage before use.
TUFQ
Start the product by pressing
low frequency start/stop button
of the controller.
CH1
CH2
CH1
CH2
CH1
CH2
Controller Receive Sensor
Press the power switch on
the side of the power cord
connection unit to turn on the
product.
CH1
CH2
· To replace your controller’s battery, flip the controller upside down,
pull the slider at the bottom and ensure you put the battery cell facing up
as shown in the image.
FRONT BACK
ON
Power
OFF
CH2 CH1
To Next Page
Loading...
