MAGNUM
Page 18
keep all guards and shields in place. The tractor master shield and
implement shield must be installed to work with the driveline guard and
provide the intended coverage. (3)
THE OPERATOR'S MANUAL
* Read the manual! (4)
* Understand the contents!
* Heed all safety messages in the operator’s manual and safety signs on machines
PRE-OPERATION REQUIREMENTS
* Be sure to disengage the PTO shaft and turn off the tractor before making any
inspections or working around the PTO driveline.
* Follow the manufacturer’s recommendation for attaching the implement to the
tractor. Make sure the distance from the tractor PTO shaft to the hole in the drawbar
is the distance recommended by the implement manufacturer in the operator’s
manual. (5)
* If your drawbar has an offset end, be sure it is in the down position so it won’t
interfere with the driveline guard when you are using PTO-driven equipment. Make
sure your three-point hitch and drawbar are correctly positioned so neither interferes
with the driveline. Lock the three-point hitch when you are not using it.
* Use a drawbar hitch pin with a low head. When the hitch pin or other parts of the
To Next Page
Loading...
Need help?
General