MAGNUM
Page 22
MAINTENANCE
When replacing the driveline guard:
* Make sure the proper guard bearings are used for installation.
* Lubricate the bearing grooves per implement manufacturer’s recommendation.
* Make sure the ADMA safety sign is on the replacement guard.
* Install the ADMA “Guard Missing” safety sign to the outer telescoping member.
(14)
* If the driveline is old and will not accept a guard, replace the driveline!
Don’t modify the driveline when you repair or replace it. The driveline was
engineered and manufactured for a specific implement application.
Proper maintenance of all shields, guards, and overload devices is important to safe
operation. A shield must be fitted to the implement input connection so that it will
overlap with the driveline guard.
To Next Page
Loading...
Need help?
General