for setting temperature, checking & setting parameters, etc.
2.3.2.3 Temperature Setting: When the wired controller is on, press“ ”or“ ”，the temperature
data on the screen will show up, then press “ ”or“ ”to add or reduce
，
then press“ ” to confirm the
modifying, or after 20 seconds without any operation, it will automatically quit from the temperature
setting, and store the current modified data, press“ ” or “ ” without stop for over 0.5 second to start
quick adding or substracting.
2.3.2.4 Key locked function: First press “ ”, then press “ ” for 3s to enter or exit key locked
function, when “ ”symbol show up means wired controller locked.
2.3.2.5 Inquiry running parameters
2.3.5.1 Enter inquiry: first press “ ”then press “ ” for 3 s to enter parameters setting status,
temperature display area display parameter number, setting temperature area display parameters
content.
2.3.5.2 Inquiry operation and exit: after entering running parameters, press “ ”or “ ”to display
each running parameter; press “ ”to exit inquiring parameters status or if there is not any pressing
keys operation will automatically exit inquiring parameters status after 20s.
2.3.2.6 Common parameters setting
1.3.6.1 Enter setting ; first pressing “ ” then press “ ” for 3 secs,the temperature display area
display “00” and blinking display ,input the password (default password “Fb”),then press “ ”or “ ”to
add or subtract ,press “ ”or “ ” to confirm ,if the password is wrong then exit current status ; if the
password is correct then enter parameter modification status ,temperature display area display
parameters number and blinking display ,setting temperature area display parameter content ;
1.3.6.2 Setting operation : after entering setting parameters, the parameter number blinking
display ,press “ ”or “ ”switch line to display each setting parameters number ,then press “ ”the
parameters content blinking display ,press “ ”or “ ” to modify current content ,after finishing press
“ ” to save current modification then back to parameters number display status .
1.3.6.3 Exit setting; press “ ”to exit parameters setting status or if there is not any pressing keys
To Next Page
Loading...
Need help?
General
