operations then quit current timing setting and exit timing setting status .
2.3.2.9.4 Cancel timing setting; after enter timing setting status, long press “ ” for 3 secs to cancel
the configured timing function.
2.3.2.10 Memory function : in shutdown status ,long press “ ” for 3 secs,the LCD display
“POSET”then enter memory function setting ,press “ ”or “ ”to set value as “on” or “off ”;If value is
“on ”,the wired contact memory setting status before powering off .if value is “off ”wired controller
memory shutdown status .
2.3.2.11
、
Back light setting ; in shutdown status ,long press “ ” for 3 secs, the LCD display “LCD
SET” then enter back light setting ,press “ ”or “ ”to adjust the brightness. Press any keys except
“ ”or “ ” to save setting or if no any keys operation in 5s the controller will save current setting and
exit.
2.3.2.12、Running Parameters List:
Inverter compressor current actual frequency
Inverter compressor operation(input) current
Water supply pipe temperature
Evaporator coil temperature
After throttling temperature
Opening of EXV(shown as the actual opening )
To Next Page
Loading...
Need help?
General
