PIE1045 - Indice B – Mars 2020 22/76
FULL HD 1296P (1728x1296) / FULL HD 1080P (1920x1080) /
HD (1280x720) / WVGA (848x480) / VGA (640x360)
Higher resolution produces better quality videos but creates larger
files that take up more of the SD card capacity (fills up faster).
Default setting: 10 seconds
Programmable from 5 up to 180 seconds
Default PIR interval: 20 seconds
Photo mode: programmable from 5 seconds up to 60 minutes
Video mode: programmable from 10 seconds up to 60 minutes
Photo + Video mode: programmable from 10 seconds up to
60 minutes
Allows you to set the desired time interval between photos/videos
when motion is detected. This function avoids taking too many
photos / videos.
Example: if the PIR interval is set to “01 min 00 sec”, the camera
will wait 1 minute between each photo/video recording even if
motion is detected.
High / Medium / Low
High sensitivity:
1) is more sensitive to movements by smaller subjects;
2) offers longer detection distance;
3) makes it easier for the PIR sensor to detect a difference
between body heat and outdoor temperature;
4) makes it easier to trigger the camera.
In high temperature environment, subjects body heat and
environment temperature are hard to tell by the camera, the
recommended setting is high.
In environments with lots of interference like hot wind, smoke,
near window, etc., the recommended setting is low.
Auto / Maximum / Minimum
− Auto: the camera automatically adjusts the brightness of the
infrared flash according to the battery level. This setting is
recommended.
− Maximum: the infrared flash will work with the highest
brightness and the energy consumption will be high.
− Minimum: the infrared flash will work with the lowest
brightness and the energy consumption will be low.
To Next Page
Loading...
