SL1008 - Indice A 57/200
• Press the [UP] or [DN] button to increase or decrease the
time value from 5 seconds (00:05) to 60 minutes (60:00)
in 5-second increments.
• Press [OK] to save the Time Out setting.
• You’ll then see the word “T” (Time) blinking. Press the
[OK] button to enter the time setting or the [M] button to
exit.
Setting the Time and Date in PIR or TLM operation
mode
Your camera uses the 24-hour military time format.
WARNING: when changing the batteries, the time and date
setting is lost.
• Slide the switch to the SET position, the status display will
show the camera current status.
• Press the [M] button once to enter the Manual
programming mode.
• The word “PIR” or “TLS” will be blinking, press [OK] to
confirm the camera’s operation is PIR detection or TLM.
• Press the [UP] or [DN] button until the letter “T” is
blinking.
• Press [OK] to enter the Hours setting.
• The Hours digits will be blinking.
• Press the [UP] or [DN] button to increase or decrease the
hour value (00 – 23).
• Press [OK] to save your selection and enter the Minutes
To Next Page
Loading...
