SL1008 - Indice A 70/200
• Insert the other end into the RCA VIDEO IN jack on the TV.
• Turn on the camera power by sliding the switch from OFF
to A, B, MANUAL or SET, and turn ON the TV.
• Make sure to switch to AUX / VIDEO IN mode on your TV.
See your TV owner’s manual for directions.
• The camera’s AV is set to PAL by default. (PAL – Standard
European TV format).
If the TV monitor doesn’t flicker, then you do not need
to change your camera’s AV setting. Proceed to the next
section called Thumbnail Images.
If the TV monitor does flicker, then you will need to
proceed to the next step “TV Out System Settings” to
change your camera’s TV OUT from NTSC to PAL
(Standard European TV format).
• You will see a series of thumbnail images on your TV.
• Press the [UP] or [DN] button to navigate though the
thumbnail images.
• On the lower left hand corner of your TV
monitor, it will either display the image OR
the image with a video icon which indicates
it’s a video clip.
• To view in full screen, press the [OK] button.
• Press the [OK] button again and it will return to the
thumbnail view from the full screen image.
NOTE: All videos are recorded with audio but only
have sound when viewing playback on a PC.
To Next Page
Loading...
