Num'axes SL1008 - TV Out System Settings; Deleting files in the field

SL1008 - Indice A 71/200
TV Out System Settings
• Press the [M] button once.
• The word “tu” will be blinking on the camera’s screen.
• Press [OK] once and now you’ll see “tu – n” blinking.
• Press the [DN] button to set the camera’s TV OUT to PAL.
• The word “tu – P” will now be blinking.
• Press [OK] to confirm this setting.
• The word “tu – P” will be blinking and then will stop.
• Once the blinking stops, power off the camera. Wait for
5 seconds and then power up your camera again.
Deleting files in the field
• Slide the switch to the SET position, the status display will
show the camera current status.
• Press the [M] button once enter the Manual
programming mode.
• The word “PIR” will be blinking, press [OK] to confirm the
camera’s operation is PIR detection.
• Press the [DN] button until you see the word
“- dEL –” blinking on the status display.
• Press the [OK] button to enter the d-ALL (DELETE) & F-t
(FORMAT) menu.
• Press the [UP] or [DN] button to select the desired
function:
 NO-dL (No Delete) - No images get deleted.
 d-ONE (Delete One) - Only the last file will get deleted.