CD MIX-2
- The Leader in DJ Technology
©2001 Numark Industries
- 14 -
http://www.numark.com
MOVING LOOP POINTS
The “LOOP IN” point can be moved while a loop is playing just by pressing the “LOOP IN” button at the new desired point.
The next time “LOOP OUT” is reached the CD will return to this new “LOOP IN” point. If you should accidentally set a
new “LOOP IN” point at the same place as your “LOOP OUT” point the “LOOP OUT” point will be erased and play will
continue.
Note: If for any reason you should press pause then play to restart a track in between
these loop points, setting a new cue point, this will also set a new “LOOP IN” point.
The “LOOP OUT” point can also be moved while a loop is playing just by first pressing this button to release the old
“LOOP OUT” point and pressing it again at the new desired point.
RELOOP
The “RELOOP/STUTTER” button performs 2 different functions depending on your state of play. The Reloop function is
possible only if “LOOP” points have been previously set and the CD is playing beyond the “LOOP OUT” point.
The “RELOOP” button automatically causes a loop to be played again until it is released with the “LOOP OUT” button.
The LEDs will flash during the loop and then become solid following the loop.
The second function of this button is described in the section called “STUTTERING FUN”
To Next Page
Loading...
Need help?
General
