To Next PageTo Next Page
Need help?Do you have a question about the Numark CM 200 and is the answer not in the manual?
Input Specifications| line input impedance | 10Kohm |
|---|---|
| mic input impedance | 600 ohm |
| phono input impedance | 47Kohm |
Output Specifications| line output voltage | 9V rms max |
|---|---|
| headphone output power | 0.5W into 47 ohm |
| distortion | less than 0.01% |
Signal to Noise Ratio| line signal to noise ratio | Better than 98dB |
|---|---|
| mic signal to noise ratio | Better than 86dB |
| phono signal to noise ratio | Better than 81dB |
Frequency Response| line frequency response | 20Hz-20KHz ±0.5dB |
|---|---|
| mic frequency response | 20Hz-15KHz ±0.5dB |
| phono frequency response | ±1dB except for controlled attenuation of –3dB @ 20Hz |
Power Consumption| typical power consumption | 11 Watt |
|---|---|
| power consumption with full headphone output | 14.7 Watt |
Connect turntables with RIAA phono preamplifiers. Use line inputs for line-level turntables.
Connect line-level audio devices like CD players, tape decks, or samplers.
1/4" connector input for connecting DJ microphones directly to the mixer.
Low-impedance XLR connectors for master output, controlled by the master fader.
Connects the unit to AC power using the supplied power supply cord.
Adjust to the correct voltage setting for your geographical location.
Turns the mixer on/off. Connect devices before powering on.
Primary jack for connecting DJ microphones with XLR or 1/4" connectors.
1/4" terminal for connecting headphones. Set volume low before connecting.
Activates remote start for compatible CD players via pulse commands.
Details input impedance and sensitivity for Line, Mic, and Phono connections.
Specifies maximum output levels for Line and Headphone connections.
Provides JIS-A weighted signal-to-noise ratios for Line, Mic, and Phono.
