Numark MixTrack Pro FX User Manual

2
User Guide (English)
Introduction
Box Contents
MixTrack Pro FX
USB Cable
Software Download Card
User Guide
Safety & Warranty Manual
Support
For the latest information about this product (system requirements, compatibility information, etc.)
and product registration, visit numark.com.
For additional product support, visit numark.com/support.
Setup
1. Place MixTrack Pro FX on a flat, stable surface.
2. Make sure all devices are turned off and all faders and gain knobs are set to “zero”.
3. If using a microphone, connect it to MixTrack Pro FX’s microphone input.
4. Connect MixTrack Pro FX’s outputs to power amplifiers, tape decks, and/or other audio
sources.
5. Plug all devices into AC power and connect MixTrack Pro FX’s USB port to a computer’s USB
port using the included USB cable.
6. When powering everything on, power on your devices in the following order:
• (1) Your computer, (2) any amplifiers, speakers, or output devices
7. Locate the Serato DJ Lite installation card in the box to download and install the software.
8. Open your software program and load music to the decks.
9. Start DJ’ing!
10. When powering everything off, power off your devices in the following order:
• (1) Any amplifiers, speakers, or output devices, (2) your computer
Connection Diagram
Items not listed under Introduction > Box Contents are sold separately.
Computer
Speakers
Headphones
Microphone

Numark MixTrack Pro FX Specifications

General

Type	DJ Controller
Channels	2
Jog Wheels	2
Software	Serato DJ Lite
Number of Decks	2
EQs	3-Band EQ per channel
Audio Interface	Built-in
Crossfader	Yes
USB Connectivity	USB Type-B
Outputs	RCA stereo output
Headphone Output	1/4" and 1/8"
Mixer	2-channel
Pad Controls	Sampler
Software Compatibility	Serato DJ Lite
Performance Pads	8 per deck
Faders	2 x Volume, 2 x Tempo