Numark TT200 User Manual

SETUP & INSTALLATION
This turntable has been designed exclusively for DJ use and can be setup in a variety of different ways
depending on your mixing style. The turntable should rest on a level and stable surface that is clear of
obstructions. If a mixer is placed between two turntables make sure that there is at least ¼" (7mm)
between the mixer and the turntables to prevent damage to the turntables and to reduce unwanted
system noise.
Mixer
Mixer
85 mm
¼" ¼"
Mixer
¼" ¼"
Setup Style 1 (traditional)
Best For:
Long mixes and blending
techniques
Setup Style 2 (battle style, scratching)
Mixer
Best For:
Scratching, cutting, and aggressive
mixing techniques
There are many variations of these setups. Find the best setup that works for your mixing style by
experimenting with different turntable and mixer placements. It is strongly recommended that the top
mixer surface and the top flat surface of the turntable be at the same level.
SETUP & INSTALLATION PAGE 2

Numark TT200 Specifications

General

Drive Type	Direct Drive
Platter	Aluminum die-cast
Start/Stop Button	Yes
Reverse Button	Yes
S/N Ratio	>50dB
Braking System	Electronic brake
Platter Diameter	330 mm
Cartridge	Not included
Outputs	RCA
Speeds	33 1/3, 45 RPM
Pitch Control	+/- 10%
Tonearm	S-shaped
Start-up Time	<0.7 sec
Dimensions	450 x 352 x 144 mm
Motor	High-torque direct drive motor