CONTROLS continued
Bottom Parts
20. Adjustable Rubber Dampening Feet
When all of the feet of the turntable are completely tightened, the top flat surface of the turntable will be at
85mm. Unscrewing these feet raises the turntable up to compensate for unleveled surfaces.
21. Carrying Handles
These handles provide a secure grip so that the turntable may be comfortably transported.
22. Voltage Selector
This switches the internal voltage transformer between 115V, 230V and 240V. The turntable should be shipped
with the proper voltage setting for your region. Check that the switch is in the proper voltage before
connecting the IEC power cord to prevent damage to the turntable.
23. IEC Power Terminal
This IEC Power Terminal can be used with any IEC power cable, but it is recommended that the supplied IEC
power cable be used.
24. RCA Output
These stereo output jacks allow the turntable to be connected to a compatible device with a PHONO level input.
25. Ground Terminal
This ground terminal is used to run a ground line between the turntable and the device it is connected to.
20
21
x4
x4
24
25
22 23
PAGE 6 CONTROLS
To Next Page
Loading...
Need help?
General
