Numatic TTB 4045/100 User Manual

TTB 4045/100
TTB 4055/100
ETB 4045/60
Original Instructions
Warning! Read instructions before using the machine.
Warnhinweis
Lesen Sie vor Gebrauch der Maschine das Handbuch.
Attention
Lisez la notice avant d’utiliser la machine.
Waarschuwing
Lees deze instructies voor u de machine gebruikt
Owner Instructions
Bedienerhandbuch
Mode d’emploi
Bedieningshandleiding voor de gebruiker
www.numatic.com

Numatic TTB 4045/100 Specifications

General

Model	TTB 4045/100
Type	Scrubber
Working Width	450 mm
Brush Speed	150 rpm
Brush Motor Power	400 W
Power	24 V
Brush Size	450 mm
Pad Size	450 mm
Cleaning Width	450 mm
Noise Level	68 dB
Power Supply	Battery
Battery	2 x 12 V

Summary

General Safety and Information

Operational Warnings and Advice

Important warnings and advice on safe operation and usage.

Battery Management

Precautions When Working With Batteries

Essential safety measures when handling and working with batteries.

Battery Care Guidelines

Quick Set-Up Guide

Handle Positioning and Fuse Installation

Steps to set the handle and install the fuse.

Connecting Tanks and Power

How to connect tanks, vacuum hose, and switch on the machine.

Filling the Clean Water Tank

Instructions for filling the clean water tank.

Machine Set-Up

Fitting the Brushes

Instructions on how to fit the Nulock brush system and PadLoc system.

Floor Tool Setup

Fitting and Lowering the Floor Tool

Filling the Clean-Water Tank

Chemical Handling and Pre-Cleaning

Control of Substances Hazardous to Health (COSHH)

Guidance on using chemicals safely and following COSHH regulations.

Machine Operation

Pre-Scrub Mode

Floor Tool Usage

Setting Cleaning Controls

Machine Modes and Operation

Regular Maintenance

Cleaning Waste-Water Tank and Separator

Cleaning Filters and Clean-Water System Components

Floor Tool Maintenance

Changing the Floor Tool Blades

Machine Charging and Battery Care

Trouble Shooting

Machine Specifications