Belt Path:
With base: (cont.) Press release button on bottom of base to release
stability leg (diagram 5). Open lock-off and route vehicle belt over base and
buckle. Route lap belt under tabs in lap belt path, route shoulder belt diagonally
over shoulder belt path under lock-off. If belt comes in contact with positioner
on side of base, route belt under positioner (diagram 6). Tighten vehicle belt
and close lock-off. Once base is correctly installed, push adjustment button on
load leg and extend leg until foot makes contact with vehicle floor. Lock leg
into place using first position that firmly locks leg into contact with vehicle
floor. Make sure indicator on foot shows green, not red (diagram 7). If load leg
lifts base more than 1 inch off the seat, adjust as needed to close the gap.
Load leg may not be used over vehicle floor storage compartment
unless expressly permitted by vehicle manufacturer.
Without base: This child restraint may not be used in a vehicle
without the base.
LATCH: Restraint has rigid lower connectors. LATCH bars may be used in
center seating position only when the position is designated as a LATCH location
in vehicle owners manual and when spacing is 11 inches. Rotate connectors down
and point them away from base (diagram 8), unfold load leg from beneath base
(diagram 5). Attach connectors to vehicle lower anchors, making sure green is
showing on connectors (diagram 9), then adjust stability leg to make contact with
vehicle floor until indicator turns green (diagram 7).
SEE PAGE 3
Important: This information sheet is not a substitute for complete manufacturer’s directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 318-5111 (800)745-SAFE ©SafetyBeltSafe U.S.A. #450 06/21
9
5
6
7
8
P. 2 of 3
Nuna Pipa Lite R
To Next Page
Loading...
Need help?
General
