1 - Snap the chest clip together and temporarily
slide towards buckle for tightening of harness.
2 - Tighten harness by pulling on the harness
adjustment strap. Pull any excess harness
webbing through the buckle towards the child’s
shoulder and pull on the harness adjustment
strap. This may need to be repeated several
times for proper fit.
Verify that the harness is snug around the
child’s waist and shoulders.
3 - Position the chest clip so it is at child’s armpit
level.
Check that Child is Secure
Buckle is fastened.
Harness straps are not twisted.
Harness is snug – A snug harness cannot be
pinched, and should not allow any slack.
Chest clip is level with armpits.
Harness straps must be at or just below child’s
shoulders to avoid injury. If harness slots need
to be moved, see shoulder belts section.
Make sure that nothing interferes with the
harness. Make sure harness is snug around
child and lays flat.
If child is not secured properly, child could
be ejected in a sudden stop or crash, resulting
in serious injury or death.
1
2
3
28 PIPA lite series instructions 29PIPA lite series instructions
To Next Page
Loading...
Need help?
General
