Nuna Pipa Lite Series User Manual

Installation
1 - WARNING Serious injury
or death can occur. The seat alone cannot be
installed in the vehicle. It must be installed with
the base.
Installation in an Aircraft
When used with the base, This Restraint is
Certified for Use in Motor Vehicles and Aircraft.
Install the base on an aircraft by following the section
Installation Using Lap and Lap/Shoulder Belt on page
36. It may be necessary to shorten the lap belt by
twisting it, to achieve a proper installation.
Installation on a Stroller
This infant carrier can attach to Nuna strollers as
well as other brands of strollers using adapters.
Please visit nuna.eu for more information.
Base Installation Using Rigid LATCH
(Lower Attachments)
2
- Place vehicle in park and on level ground.
3 - Position base in a forward facing vehicle seat.
Adjust base so bubble touches line.
4 - If necessary, use recline adjustment to position
bubble in level indicator to achieve correct
angle for installation. Recline adjustment locks
into position.
5 - To release recline adjustment, press down on
lock button located under base.
6 - If necessary, install rigid LATCH guides on
vehicle LATCH lower anchor bars.
1
2
3
4
5
6
30 PIPA lite series instructions 31PIPA lite series instructions

Nuna Pipa Lite Series Specifications

General

Usage	4 to 32 lbs, up to 32 inches
Safety Features	Side impact protection
Base	Included
Material	Lightweight aerospace aluminum
Compatibility	Nuna strollers
Harness	5-point harness
Safety Standards	Meets or exceeds FMVSS 213
Weight	5.3 lbs