EN
28 PIPA instructions
Installation Instructions
Base Install - Rigid UAS
(Lower Attachments)
1 - Place vehicle in park and on level ground.
2 - If necessary, install plastic connector guides on
vehicle UAS lower anchor bars .
3 - Hook Rigid UAS (lower attachments) onto
vehicle UAS lower anchor bars. Confirm
proper installation by pulling on the base AND
also seeing that green is indicated on the
connectors.
The Rigid UAS (lower attachments) must be
attached and locked onto the vehicle anchor
points.
4 - Adjust the angle of the base. A rolled up towel
or foam pool noodle may be used to help adjust
the amount of recline. Angle is correct when
blue line on carrier is levelled with ground.
Check the Installation
Place carrier in the base and ensure blue line is
levelled with ground.
It is acceptable to install with both UAS (lower
attachments) and the vehicle belt.
To Next Page
Loading...
Need help?
General
