EN
30 PIPA instructions
1 - After child is properly secured in carrier, press
carrier on base and listen for a click. Pull on
carrier to verify installation.
DO NOT allow carrier or handle to contact
interior of vehicle.
Your child may not be protected in the event
of a crash or sudden stop if you do not check
and verify that it is securely attached.
2 - To release the infant child restraint, pull the
infant child restraint up while squeezing the
infant child restraint release button located on
the base.
3 - To remove the base, first push the base
toward the vehicle seat with a light force while
squeezing the Secondary and Primary Rigid
UAS Release Buttons.
4 - Then pull the base out.
*For ease of release, push the secondary button first, then the
primary button.
To Next Page
Loading...
