EN
36 PIPA instructions
Carrier Only Install
1 - Place vehicle in park and on level ground.
Position carrier so that child is facing the rear
of the vehicle.
Only install in a forward facing vehicle seat.
(Page 8)
2 - Route the vehicle lap belt under both lap belt
guides and buckle the vehicle belt.
3 - Route the shoulder belt around the back of the
carrier passing through the blue shoulder belt
guide.
4 - If you are unable to route the shoulder belt
around the back of the carrier, use only the lap
belt. Allow shoulder belt to lay against vehicle
seat back as shown.
5 - If your vehicle only has a lap belt, shoulder belt
will not be used.
6 - Adjust the angle of the carrier. A rolled up
towel or foam pool noodle may be used to help
adjust the amount of recline. Angle is correct
when blue line on carrier is level with ground.
To Next Page
Loading...
Need help?
General
