6
OPERATION
Before using heater, make sure heater has been properly installed according to
installation steps beginning with the "PLANNING" section on page 1.
Two-bulb units can be fitted with one infrared bulb (for heat) and one reflector
bulb (for light). Dual or multi-controls can be used for separate control of bulbs
and/or exhaust fan. Purchase controls separately.
MODELS 9417DNM & 9425WHC OPERATION NOTE: These units are de-
signed with a thermostat which senses excess heat and may start the blower
automatically. This is normal and is no cause for concern.
To Next Page
Loading...
