To Next PageTo Next Page
Need help?Do you have a question about the NuTone AER110LTK and is the answer not in the manual?
General| Airflow | 110 CFM |
|---|---|
| Sound Level | 1.5 sones |
| Heater | Yes |
| Voltage | 120 V |
| Housing Material | Galvanized steel |
| Mounting Type | Ceiling |
| Duct Size | 4 inches |
| Certification | UL Listed |
To reduce the risk of fire, electric shock, or injury to persons.
For general ventilating use only. Do not exhaust hazardous or explosive materials.
For quiet and efficient operation, long life, and attractive appearance.
Use an on/off switch or speed control to operate this ventilator.
Ducting affects airflow, noise, and energy use; use shortest, straightest runs.
Remove blower, packing material, and wiring panel from fan housing.
Attach flanges and grille brackets to the fan housing.
Push connector through opening and secure with screw.
Ensure housing is flush with finished ceiling and secure it.
Connect 4-in. round duct and power cable as per diagram.
Enlarge ceiling opening if necessary and leave ductwork and wiring.
Attach mounting plate, connect light panel, and install grille frame.
Details on mounting plate, light panel, and grille springs.
Connect power cable to housing and make wiring connections.
Pull existing ducting through opening and attach to duct connector.
Mount fan housing to ceiling structure with screws.
Schematic showing electrical connections for the fan and light.
