3.
4.
Press AM
or
FM
pushbutton for the radio function you desire.
The
light will illuminate
beside the selected function.
5.
To tune your radio to desired frequency, use one of the following methods:
(a)
RAPID
TUNE- Depress and hold either of the 'arrowed' pushbuttons until you
reach the station you want, then release the pushbutton.
(
b)
STEP
TUNE-
Momentarily touch
either
of the arrowed pushbuttons
and
the
tuner
will
move to the nearest radio frequency on the band.
( c)
AUTOMATIC
SCAN-
Momentarily touch the "SCAN" pushbutton and
the
tuner
moves up the radio dial to the nearest strong signal. It remains
on
this signal for
five
(5)
seconds, them moves to the next nearest strong
signal_
When the desired
station
is
found, press the 'SCAN' pushbutton to stop the automatic operation.
(d)
MEMORY
-Choose
your favorite radio stations for instant recall when you touch
one
of
the five memory pushbuttons. Five
FM
and five
AM
stations are easily
placed into the radio memory using the following procedure:
Set the radio into the
FM
mode
and
tune to the station you want. Touch
'MEMORY'
and then the first pushbutton.
Repeat
this for the five stations
that you desire, touching 2, 3,
etc
. NOTE:
For
your convenience, it
is
recom-
mended that you
enter
the lowest frequency into the first position, the next
highest into the second position, through the five positions.
Switch to the
AM
mode and repeat the procedure.
NOTE:
This radio-intercom includes a battery backup. In the event of an
electrical power failure, the ten-station memory will be retained and the clock
will keep time for up to 30 hours.
The
digital display will
not
be lighted.
The
life expectancy of the battery
is
5 to 7 years (See page
10
of
this manual for
battery replacement procedure).
In all cases, while setting the radio station, the digital display will show the radio
frequency for approximately five
(5)
seconds then return to
the
clock display. To
check the radio station that
is
being listened to, press the frequency pushbutton.
The
radio frequency will be displayed for 5 seconds and will automatically return to the
clock function.
6.
After the radio station has been selected, adjust the following:
(a)
Volume levels as desired
(b)Tone control as
required-left
to right will increase treble
and
reduce
base-
right to left will increase base and reduce treble.
(c) If a boost
in
the highs
and
lows (treble and base)
are
desired, push the loudness
switch
ON.
This
is
located behind
the
intercom control door.
--·
J
CLOCK
SET
J
~=
I
10::10
I
FREQUENCY
A.
c::::::::::J
J
HOUR
D
SCAN
c=:::::]
J
~
J
....
c=:::::]
J V
'-
:::J
:J
MEMORY
::J
AM
•
c:::::::J
c::::::J
::J
FM
1
::J
•
c:::::::J
c::::::J
::J
PHONO
~
I
I
©»
2
::J
•
c:::::::J
c::::::J
::J
TAPE
3
•
c:::::::J
c::::::J
:::J
:::J
MIC
4
t,:J
c:::::::J
c:::=::J
:J
MESSAGE
5
,
Lc:::::::J
c::::::J
To Next Page
Loading...
