NuTone IM-4006 Series

5.
Determining Speaker Locations
Each
SPEAKER
STATUS
SWITCH
is
numbered
and labeled. You will want to
determine the location
of
each
speaker in your
home
and write each location on the
blank label that
is
below the switch that controls
that
speaker. To determine speaker
locations, use the following procedure:
1.
Set
all
the
REMOTE
SPEAKER
STATUS
switches to
SPEAKER
OFF.
2.
Set the
MASTER
SPEAKER
switch to
RADIO
INTERCOM.
3.
Tune
in
a radio station, then turn the
SYSTEM
VOLUME
co::itrol to maximum
(full clockwise).
4.
Slide the
MASTER
SPEAKER
VOLUME
control to minimum volume(-). Make sure
each remote speaker's
VOLUME
control is turned completely clockwise for maximum
volume.
5.
One at a time, set a
REMOTE
SPEAKER
STATUS
switch to
RADIO
INTERCOM
and locate the speaker
by
sound. Write
the
speaker's location on its label.
Repeat
the
procedure until you locate and label every speaker in your system.
Setting System Volume Controls
The
volume levels required at each station may vary with the location
of
the
speaker
and the size of the room where the
speaker
is
located. Spend some time experimenting
with volume levels and adjust each
speaker
so that you
can
clearly hear the radio
and
intercom. Use the following procedure to
set
your system's volume levels:
1.
At
each remote station, turn the
VOLUME
control completely clockwise to maximum
volume.
2.
At the master station, set all
REMOTE
SPEAKER
STATUS
switches to the
RADIO
INTERCOM
position. Set
MASTER
STATION
switch to
RADIO
INTERCOM.
3.
Slide the
MASTER
SPEAKER
VOLUME
control to maximum (
+)
volume.
4.
Turn th6
SYSTEM
VOLUME
control
on
the master station to approximately
1
/2
volume.
5.
Select an AM
or
FM radio station with a strong, clear signal.
6.
Adjust the master station's
SYSTEM
VOLUME
control until you have enough volume
at the remote station that requires the highest volume (i.e., a large living room
or
family room, a basement etc.).
NOTE:
The
master station's speaker
and
all remote stations (except the
door
speakers)
are equipped with their own volume controls. Although the master station's
SYSTEM
VOLUME
sets the system's volume level, you may adjust an individual speaker's
volume level within the set range.
7.
Adjust the
MASTER
STATION
VOLUME
control and all remote station's
VOLUME
control to the volume level you desire.
Do
not set the remote station's volume controls
below the
NORMAL
RANGE
setting.
I
I
:JOI
MASTER SPEAKER VOLUME
TONE
INSIDE/MTIO
DOOR
END
I
-I
I I I I I
normal
range+
-11111111111+
TALK
TALK
CALL
••
a
~
•
1g11g11g1
I
MICROPHONE
I
RADIO
IIITEIICOM
1~~~~~~~~~~~18]~~18]~~~
-lOlUME-
~:
I
IIITEIICOM
IJII!
0
0
•
SPEAKER
Off
I
•1111TIJR
I
I I I I I I I I I
I:.
IIITERCOM
SmEM
UJUIIIESS