To Next PageTo Next Page
Need help?Do you have a question about the NuTone NM200 Series and is the answer not in the manual?
General| Brand | NuTone |
|---|---|
| Model | NM200 Series |
| Category | Intercom System |
| Language | English |
Instructions to read all manual content before installation or use.
Ensure installation by a qualified dealer or installer conforming to local codes.
Replace fuse only with the same type 3 Amp, 250 Volt fuse for fire protection.
Follow all warnings and operating/installation instructions provided.
Refer all servicing to qualified personnel to avoid exposure to hazardous voltage.
Alerts user to uninsulated 'dangerous voltage' posing a shock risk.
Alerts user to important operating and maintenance instructions in the literature.
Locate system away from radiators, heat registers, stoves, or other heat-producing products.
Do not locate master or remote stations in an exterior wall.
Do not expose to moisture to prevent fire/shock hazards and voiding warranty.
Do not place stations in wall cavities with other electrical wiring.
Install the NM200 system after the wall covering material has been applied.
Outdoor speakers are weatherproof, not waterproof; avoid direct water exposure.
Do not connect CAT5 wire if termination point is uncertain to avoid system damage.
Ensure all rough-in instructions are followed before applying power.
Do not splice cables as splices are unreliable and defeat signal isolation.
Only attach authorized devices; audio components and CD player are examples.
Ensure extra cables are not connected to the master unit to prevent feedback.
Do not over-tighten screws on stations to prevent cracking or stripping plastic face panels.
Use only NuTone certified parts; unauthorized substitutions can cause hazards.
Ensure system is in proper operating condition with a safety check after service.
Use a damp cloth for cleaning; do not use liquid or aerosol cleaners.
Careful installation ensures high-quality music and voice reproduction.
Contact technical staff at 1-888-336-6151 for troubleshooting help.
Installation should be made after the application of wall covering material.
List of tools required for installation: Phillips screwdriver, flat head screwdriver, wire stripper/cutter, level.
Connect 18 gauge speaker cable wires to satellite speaker terminals.
Connect IA30WH cables using provided labels and mount plate.
Strip CAT5 wire, separate conductors, and connect using wire nuts.
Wire nut colored conductors to respective wires for NA300MC volume control.
Strip wire, separate conductors, terminate yellow/orange, connect red/black to speaker.
Gather, label, and strip CAT5 cables; insert into correct connector locations.
Connect outdoor remote station cables to provided screw terminal connectors.
Note: More than 9 remote stations may require switches to control two stations.
Connect door station red/black wires to speaker terminals and orange to common.
Connect each yellow wire to a note selection terminal, one wire per terminal.
Install chime module by pressing over plastic standoffs and plug in modular chime.
Suspend master unit from rough-in using the support wire assembly.
Connect FM dipole coax antenna to F connector and orange wire to AM terminal.
Connect low voltage cables from transformer and striker for door release function.
Plug in RCAT™ phono plugs to AUX jacks for source audio equipment.
Insert power plug, secure master, install speaker panel, and check functions.
Apply pressure on the speaker panel only at the corners, not in the middle.
Recheck connections if difficulties arise; contact technical support if problems persist.
Covers defects in materials/workmanship for two years from purchase date.
Excludes fluorescent starters, filters, ducting, misuse, negligence, accident, improper repair/installation.
Broan-NuTone not liable for incidental, consequential, or special damages.
Notify Broan-NuTone, provide model number, describe defect, and present proof of purchase.
Contact Broan-NuTone LLC or Canada for assistance or service.
