NUTRIBULLET JUICER PRO - Assembly & Use Steps 5-8; Step 5: Locking Handle Operation; Step 6: No-Drip Spout Adjustment; Step 7: Juice Pitcher Lid Placement

11
5 Raise the Locking Handle
and move it into the “ears” on
each side of the Basin Cover.
The Locking Handle should
be in a vertical position and
locked into place.
NOTE: if the Locking Handle is not
securely in place, the juicer will
not power on.
6 Swing the No-Drip Spout
cover up vertically so that
it is no longer covering the
juice spout.
7 Place the Juice Pitcher Lid on
top of the Juice Pitcher, and
open the locking lid latch.
8 Slightly angle the Juice
Pitcher and place it under
the juice spout. Align the
spout with the hole in the
Juice Pitcher Lid and level
out the Juice Pitcher. It will
fit snuggly into the spout to
hold it in place.