2726
7 Select one of the
programs for blending
in the nutribullet
®
Cup:
Frozen Drinks, Smoothie, or
Dressing. Each mode will
activate a preset blending
cycle. You can also select
Low, Medium, or High
speed for your blend.
8 Once blending has stopped or
you’ve achieved your desired
consistency, twist the Cup
counter-clockwise to unlock
and remove it from the Motor
Base. You will hear a “click”
when the Cup unlocks.
5 Flip the Cup downward and
set onto the Motor Base.
6 Twist the Cup clockwise
onto the Motor Base to
lock it into place. (A “click”
signals that the Cup is
locked.) This will illuminate
the Control Panel.
• ALWAYS a x the vented
Pitcher Lid to the Blending
Pitcher with the spout down
and closed before blending
to prevent ingredients from
splashing or hot ingredients
from splattering.
To prevent injuries while
blending hot, warm, or
carbonated ingredients, ONLY
use the Blending Pitcher
with the vented Pitcher Lid.
NEVER use the nutribullet
®
Cups to blend hot, warm, or
carbonated ingredients.
WARNING!
nutribullet
®
Blending Pitcher.
• CAUTION! When opening
the Pitcher Lid, be mindful
of escaping hot steam or the
splattering of hot ingredients.
• NEVER open the Pitcher Lid
or Easy-Pour Spout while
blending. Only use the Vented
Lid Cap opening to add
additional ingredients during
blending. Always reinstall the
Vented Lid Cap when fi nished
adding ingredients.
• Only use the Tamper (see
page 16 for Tamper reference)
to push ingredients closer
to the blade. Never use your
hand or other utensils.
Using the Blender Pitcher.
1 Place the Motor Base
on a clean, dry, and
level surface.
2 Add ingredients to the
Pitcher. Don’t exceed the
MAX line.
NOTE: Do not use the Extractor
Blade as a storage lid. Pressurization
of the contents may occur due to
the natural fermentation of the
ingredients. Use the To-Go Lid to store.
Smoothie
Dressing
Frozen Drinks
To Next Page
