4342
1 Make sure your Motor
Base is powered o
and unplugged from
its outlet.
2 Detach the Cup, Pitcher,
or Work Bowl from the
Motor Base.
3 Clean the individual
components as follows:
EXTRACTOR BLADES:
• Use a small brush or sponge
dampened in soapy water to
remove any residue from the
Extractor Blade.
NOTE: It’s best to clean the Extractor
Blade immediately after use to avoid
the buildup of residue.
MOTOR BASE:
• Use a warm sponge or
dishcloth dampened with
soapy water to clean the
surface of the Motor Base.
• Use a small brush to scrub
the actuator system of the
Motor Base.
OTHER ACCESSORIES:
The following components
are dishwasher-safe:
• Blade Adapter
• Blade Attachments
• Cups
• Food Pusher
• To-Go Lids
Rinse or scrub beforehand to
remove any debris.
BLENDING PITCHER:
• The Pitcher and Pitcher
Lid are dishwasher-safe. if
preferred, hand wash using
soap and water. The blades
are sharp. Take care not to
touch while washing by hand
TAMPER:
• Always wash the Tamper by
hand with soap and water.
WORK BOWL:
• The Work Bowl and Work Bowl
Lid are dishwasher-safe. If
preferred, hand wash using
soap and water. Be sure to
remove any Blade Attachments
or Discs as well as the Blade
Adapter before washing.
WARNING! NEVER wash your
nutribullet
®
part or accessory
using the sanitize or heat
cycle of your dishwasher.
Doing so can warp the part,
which can create hazardous
conditions during use that
may result in bodily injury or
property damage.
STUCK INGREDIENTS:
• To remove stubborn residue
from the Cups or Extractor
Blades, fi ll your Cup with
room-temperature water
to the MAX line and add 1-2
drops of dish soap.
• Twist on the Extractor
Blade and blend for 20-30
seconds to loosen debris
enough to scrub away with
soap and water.
• To remove stubborn residue
from the Blending Pitcher, fi ll
halfway with water and add
1-2 drops of dish soap. Blend
for 20-30 seconds to loosen
debris enough to scrub away
with soap and water.
STORAGE:
• Always store your nutribullet
®
upright with nothing on top of
it. Store accessories in a safe
place until use.
• You can store the food
processor components
within the Work Bowl. Place
the Blade Adaptor on the
center shaft, followed by
the Chopping Blade, Dough
Blade, and lastly, the Slice/
Shred Disc. Attach the Lid
once all components are
in place.
• NEVER store or leave Blades
or Discs exposed. Always
cover with appropriate lid
or cover.
For replacement
parts.
Periodically inspect your
nutribullet
®
for damage or
wear. Never operate if any of
the parts and accessories are
damaged in any manner which
may impair proper function or
create a safety hazard. Contact
Customer Service for assistance
by visiting: bulletbrands.com.au
/ bulletbrands.co.nz or calling:
AU: 1300 285 538 /
NZ: 0800 232 633.
Use only genuine nutribullet
®
attachments/accessories
specifi cally designed for your
nutribullet
®
Triple Prep System.
Aftermarket parts are not
made to nutribullet
®
specifi cations and may
damage your unit or cause
serious injury.
To Next Page
Loading...
