NUTRIBULLET NBP-200 - Page 3

54
reduced physical, sensory,
or mental capabilities, or
lack of experience and
knowledge, unless they
are closely supervised and
instructed concerning use of
the appliance by a person
responsible for their safety.
Do not blend for more than
one minute.
– Blending causes ingredients
to heat up, which builds
pressure in the Cup over
time. Continuous blending
for more than one minute
may cause the Cup to
separate from the blade,
exposing the blade or
expelling heated ingredients
— both of which can
cause injury.
– Do not run consecutive
blending cycles. Allow
contents to settle at least
10 to 15 minutes before
running another blending
cycle. DO NOT attempt to
open the Cup if it feels hot or
warm to the touch. See CUP
CAUTION section for details.
• Do not blend anything
carbonated or eervescent —
no bubbles.
– Carbonated and
eervescent ingredients
(soda, baking powder,
baking soda, yeast, some
batters, cake mix, dry ice,
or other things that become
bubbly) release gasses that
increase pressure within the
Cup. Pressure from released
gases can cause a sealed
nutribullet
®
Cup to separate,
resulting in possible injury
and/or property damage.
Note: Some protein powders
include eerevscent
ingredients. Always check
supplement ingredients
before adding.
• Do not overfill.
– Filling above the MAX line can
result in leakage. The cyclonic
action of the nutribullet
®
requires space to extract
eectively. Exceeding the
MAX line can result in leakage
and may create a dangerous
pressurization which can
cause the Cup and Extractor
Blade assembly to separate,
resulting in possible injury
and/or property damage.
• DO NOT leave blended foods
inside a sealed Cup.
– Blended mixtures can spoil
and ferment, increasing
pressure when left in the Cup.
– Use the To-Go Lid or transfer
to vented container for
storage after blending.
• NEVER LEAVE THE
NUTRIBULLET
®
UNATTENDED
WHILE IT IS IN USE.
• NEVER place any nutribullet
®
parts or accessories in the
freezer or use as a storage
container in the freezer.
• Make sure your nutribullet
®
is
powered o and the motor and
blades are completely stopped
before removing or cleaning
unit.
• Remove and safely discard
any packaging material or
promotional labels before
using the appliance for the first
time.
• Periodically inspect your
nutribullet
®
Cup for damage
or wear that may impair proper
function or create a safety
hazard.
• Do not operate if any of the
parts and accessories are
damaged in any manner which
may impair proper function
or create a safety hazard.
Contact Customer Service for
assistance at:
AU: 1300 285 538 /
NZ: 0800 232 633.
• Do not use parts or accessories
from other manufacturers or
dierent models of nutribullet
®
or magic bullet
®
products. Use
of parts and accessories NOT
specifically designed for your
nutribullet
®
Triple Prep System
may damage your unit or
cause serious injury.
• Do not place or operate your
nutribullet
®
on uneven
or unstable surfaces.
• The risk of fire, shock or
damage to nutribullet
®
during cleaning can be
reduced by taking the
following precautions:
– Turn o your device and
unplug before cleaning.
– Only clean the exterior of
your device.
– Clean your device with a
dry cloth.
• Do not attempt to clean the
Motor Base by immersing in
water or other cleaning liquids.
Only gently wipe and dry with
a clean cloth.
• Do not place or operate your
nutribullet
®
on or near a hot
gas or electric burner, or in a
heated oven.
NEVER wash your nutribullet
®
part or accessories using the
sanitize or heat cycle of
your dishwasher. Doing so
can warp the part, which
can create hazardous
conditions during use that
may result in bodily injury or
property damage.
WARNING!