To Pulse, push and twist the
nutribullet
®
Cup onto the
Power Base. Press the Pulse
Button within 5 seconds of
blending, which will pause
current blending cycle to
activate manual pulse mode.
The Pulse Button will flash
BLUE indicating that it's in Pulse
Mode.
NOTE: Pulse Mode is active for 1 minute
and then times out. If the Vessel is still in
the ON position, nothing will happen. The
Vessel must be rotated counter-clockwise
to OFF position and then normal function
may be resumed.
Pulse mode.
Because the nutribullet’s motor
is so powerful, it emulsifies
the ingredients when you
extract. That is why when
you want to make foods such
as chunky salsa, or coarse
chopped onions, Pulse Mode
is key. Pulsing takes a tiny
bit of getting used to, but
once you get a feel for it,
you’ll be a Pro in no time!
1
pulse
button
PULSE
2
PULSE
Press and hold the Pulse Button
to make the Blades turn. Release
the Pulse Button to stop the
Blades. Let the Blades come to a
complete stop after each Pulse
and press the Pulse Button again
until you get the consistency
you desire.
CAUTION: Do not run the Motor Base
in excess of 1 minute per interval. Do not
run the Motor Base for more than three
1-minute intervals without allowing it
to cool for 2-3 minutes after the third
extraction. Running the motor for more
than 1 minute consecutively in any interval
may warm the ingredients and pressurize
the nutribullet
®
Cup.
Friction from the rotating Extractor Blade
when extracting can cause ingredients
to heat and generate internal pressure
in the sealed vessel. If the vessel is warm
to touch, allow to cool before carefully
opening pointed away from your body.
3
PULSE
1312
To Next Page
Loading...
