NUTRIBULLET PRO+ - Shake Technique; Tap Technique

26 27
1 Remove the vessel and Blade
assembly from the Power Base.
2 With the vessel and Blade
assembly in hand, shake it like a
cocktail shaker. Then put it back
on the Power Base.
3 To turn off the NutriBullet —
simply twist in the opposite
direction (to the right) to release
the tabs and stop pressing down
on the vessel. Once the Power
Base stops completely, remove
the vessel from the Power Base.
SHAKE
TECHNIQUE
Sometimes, if you pack down the ingredients in the
vessel or don’t put in enough water, the results can
increase the density of the mixture. This makes it hard
for the ingredients toward the top of the vessel to make
it down to the Blade. If some of your ingredients are
having a hard time making it down to the Blade, simply
use the Shake technique.
TAP
TECHNIQUE
For really stubborn ingredients that are clinging to the
side of the vessel, simply use the Tap technique.
1 Remove the vessel and Blade
assembly from the Power Base.
2 Tap the Blade side of the vessel/
blade assembly on the counter
with enough force to dislodge
ingredients from the sides of the
vessel. Be careful not to tap too
hard to avoid damaging the unit.
3 Return the vessel and Blade
assembly to the Power Base
and resume blending. Repeat
if necessary.
CAUTION:
• Do not run for more than 3 consecutive 1-minute intervals to prevent
overheating of the mixture.
• Friction from the rotating blade when extracting can cause ingredients to heat
and generate internal pressure in the sealed vessel.If the vessel is warm to
touch, allow to cool before carefully opening pointed away from your body.