-29-
Condition Cause Correction
OCC OUT
• The pump detected a
downstream occlusion between the pump and
the patient.
• The pressure sensor area is dirty (Fig 1, position 5
& 6).
• Stop the alarm by pressing the “START/STOP” key.
• Remove the feeding set out of the pump and check the permeability by flushing
the line.
• Check the permeability of the feeding tube.
• Re-insert the feeding set in the pump and restart.
• Clean the sensors, reinsert the feeding set in the pump and restart the pump.
OCC OUT
(repeated)
• Calibration not yet completed
on the current feeding set
• Stop the alarm by pressing the “start/stop” key.
• Start the pump by pressing the “start/stop” key and let it run only briefly.
• Stop the pump by pressing the “start/stop” key insuring that there has been no
occlusion out alarm.
• Remove the feeding set from the pump and reinsert the feeding set in the
pump.
• Restart the pump by pressing the “start/stop” key.
LOCK
• Only the current feeding
schedule is allowed for this patient. Another fee-
ding program is not allowed by your healthcare
professional.
• The programming feature is blocked in the set up mode of the pump. Ask your
healthcare professional to modify this setting.
ER01 - ER99
• The self test detected
an electronic error
• Turn the pump “off”, make sure the pump door is closed and switch the pump
back “on”. If the error persists, contact your healthcare provider or refer the
pump to service.
ER40
• Keypad pressed or stuck during pump start up. • Restart pump by ensuring keypad is not pressed.
No plug symbol visible,
while the pump is con-
nected to the mains.
• The wall outlet doesn’t work.
• The charger is damaged.
• Connect the pump to another wall outlet.
• Contact your healthcare professional or
Nutricia subsidiary to replace the charger.
403259622_r0.indd 31403259622_r0.indd 31 13/04/23 3:19 AM13/04/23 3:19 AM
To Next Page
Loading...
