Nutricia Flocare Infinity - Changing Feeding Program; Clearing Pump Memory; Battery Operation and Charging

TO CHANGE THE FEEDING PROGRAM DURING FUNCTIONING
• Press the “START/STOP” ke to pause the pump.
• Change the program b pressing the required ke (ml/h or DOSE=VOL) and adust using the “+” or “-” kes.
• Restart the pump b pressing the “START/STOP” ke again.
CLEARING THE MEMORy
All parameters and values can be cleared one after the other in the following wa:
• Press “START/STOP” to pause the pump.
• Select the parameter that needs to be cleared.
• Press the “CLR” ke to clear the memor. The parameter or value returns to its default value:
ml/h = 0 ml/h
VOL = cont = No dose set. Pump will feed continuousl until feed container is empt or pump
is stopped
INFO = 0 ml = Volume delivered is cleared
In order to keep a clear overview of the dail amount of feed delivered, clear the total volume delivered as
each dail feeding schedule is started, as follows:
• Switch the pump “ON”
• Immediatel after the self-test the pump displas total volume delivered.
• Press the “CLR” ke. The total volume delivered returns to “0 ml”.
• The pump displas the previous programmed flow rate (ml/h).
• The pump is in the “HOLD” mode read for programming.
• When another feeding program needs to be started, or the pump will be used for another patient, all set-
tings (rate and dose) can be returned to default and the volume delivered can be set at zero b simpl
pressing the “CLR” ke and keeping it pressed for 2 seconds.
BATTERy OPERATION
• The Flocare
®
Infinit
™
pump is equipped with a Lithium-ion batter.
• The batter smbol in the displa is automaticall replaced b the plug smbol when the adapter is
plugged in. The “fuel gauge” then indicates that the batter is charging b displaing the segments in
an ascending low to high pattern starting with the leftmost segment.
This pattern continuousl repeats while the pump is charging.
• To check the status of the batter, disconnect the charger from the pump and turn the
pump on. The bars between E and F (E=Empt, F=Full) represent the “fuel gauge” of the
batter. Each bar is approximatel 1/4 of a full batter charge. If 2 bars appear the
batter is half full and remaining operating time is approximatel 12 hours at a flow rate
of 125 ml/h.
• In case of power failure the pump automaticall switches to batter powered operation.
• When during functioning the last block is gone, the batter smbol will blink to indicate that there is approxima-
tel 1 hour of charge left. The displa will flash “BATT” ever 3 seconds, alternating with the active displa and
the pump will beep ever 2 seconds to remind the user of the low batter charge condition. Plug in the charger
to continue to run and recharge the batter.
• As the batter level decreases the pump ma not be able to deliver tube feeds at rates greater than 300 ml/h,
even though some batter capacit remains. The pump will alarm and indicate
“BATT”. If this happens, either
-71-
START/STOP
CLR
d
UK-IE
ZMNL400336_AW.indd 73 3/18/10 3:47:43 PM