nutricook SMART POT 2 - Display Messages

Display messages.
Display message when the cooker is plugged in.
Display message when cooker is on standby mode.
Display message when the pressure cooking lid is
placed on the cooker rim but not properly placed or
locked.
Display message when Smart Cooking Program
is running and under Preheating cycle (except for
Rice, Sauté, Slow Cook and Yogurt).
To restore the original settings of the Smart Cooking Programs
individually, press and hold the button of the Smart Cooking Program
you wish to restore when the cooker is on standby mode until cooker
beeps. The default settings of the cooking program will go back to the
original.
*Please refer to the Smart Cooking Programs Table for the original default settings.
To restore the original settings of the Smart Cooking Programs at
once, press and hold CANCEL button when the cooker is on standby
mode until cooker beeps.
*Please refer to the Smart Cooking Programs Table for the original default settings.
The Smart Pot has 2 temperature units – °C and °F which will
be displayed on the screen only when using Sous Vide. Default
temperature unit is °C.
To switch temperature units from °C to °F (and vice versa), press and
hold the Hour/Min button when the unit is on standby mode until C
flashes on the screen. Press + repeatedly to switch between Celsius
and Fahrenheit.
Sound On: By default, the cooker’s beep sound is On. When the unit is
on standby mode, press and hold the + button until
illuminates to
indicate that the beep sound is activated.
Note: This can only be done if the beep sound has been previously
turned o.
Sound O: When the unit is on standby mode, press and hold
the - button until illuminates to indicate that the beep sound is
deactivated.
Note: Safety alerts beep sound cannot be turned o.
Restore smart cooking programs original settings.
Change temperature unit.
Sound On/Sound o.
Display message when Rice program is running and
under Preheating cycle.
Hour and Minute indicator (First two digits refer to
hours while the last two digits refer to minutes).
• When any of the Smart Cooking Program is
running, hour and minute counts down.
• When a Delay timer is set to a Smart Cooking
Program, hour and minute counts down.
• When Yogurt is set to Low/Medium, hour and
minute counts up.
• When Keep Warm is running, hour and minute
counts up.
3736