nutricook SMART POT 2 - Anti-Block Shield: Install and Remove

The Slow Cook program does not use pressure during the cooking
process. This program cooks similar to common slow cookers using
lower temperatures.
Note: The cooking modes - Low, Med, High refer to dierent temperatures.
Follow the below steps for safe use.
1. Open and remove lid.
2. Remove the inner pot from the cooker base.
3. Add food including the liquid ingredients in the inner pot.
4. Place the inner pot into the cooker base.
WARNING: Ensure that the outside surface especially the bottom
part of the inner pot is completely dry before placing in the
cooker base.
5. Place the pressure cooking lid in the cooker base rim and lock in
properly.
6. Press down pressure release button (Venting position)
Note:
• When using Slow Cook program, the pressure release button
must always be in Venting position and ensure that float
valve does not pop up during the cooking cycle.
7. Plug in cooker to a power outlet.
8. Press Slow Cook button.
9. Press Slow Cook button repeatedly to cycle through Low, Med,
High modes for temperature options.
10. Adjust the cooking time using – or + button. Use Hour/Min
button to toggle between hour and minute fields on the screen
depending on the time that needs to be adjusted.
Slow cook.
Cooking
Program
Cooking
Modes
Suggested Use Notes
Slow Cook
Low
Corresponds to Low on
common slow cookers.
The Slow Cook function can operate with the lid
either open or close.
When the lid is closed while initiating the Slow
Cook program, the pressure release button must
be in the Venting position. Optionally, use a glass
lid for slow cooking.
Med
Corresponds to
Medium on common
slow cookers.
High
Corresponds to High
on common slow
cookers.
Note:
• Refer to the Smart Cooking Programs Table for the default
time for each cooking mode including the adjustable time
range.
11. When Slow Cook is selected, the Auto Keep Warm function is
automatically turned on which will be activated after the cooking
time has been completed. If you wish to turn off the Auto Keep
Warm function, press the Keep Warm button. The indicator light
goes off.
Note:
• You can deactivate the auto Keep Warm function during
cooking program selection or during the cooking cycle.
12. Press START to begin cooking.
Note:
• If START is not pressed after program settings, the cooker
automatically begins cooking after 10 seconds.
• Once cooking begins, time adjustments made will be
automatically saved to the Slow Cook program and selected
mode.
13. Once cooking begins, the screen displays the countdown time.
14. When cooking time has been completed and Keep Warm
function is turned off, screen displays End.
Note:
• If Auto Keep Warm is activated, the cooker goes to Keep
Warm mode immediately after the cooking cycle and counts
up from 00:00.
*See Auto Keep Warm section of this User Guide for more details.
4948