NuVinci
®
N360
TM
CVP Setup Guidelines
JAN 2011 ENGLISH
READ ME FIRST!
Chain Requirements (3/32” Only)
Due to tight clearances at the N360 Hub
Interface, the NuVinci N360 is incompatible
with 1/8 inch (3.18mm) single-speed chains.
Use only 3/32 inch (2.3mm) chains and
sprockets.
If using a NuVinci supplied 17, 18, or
20-tooth sprocket, only use 7 or 8-speed
chains (9 or higher speed chains are too
narrow for the NuVinci sprocket).
Shifter / Cable Handling
As shown in the Technical Manual, install
cable end hardware only by pulling cables at
the end of the housing (1).
Never rotate the grip (2) with cables
unattached, as they can bind inside
the shifter.
Checking Shift Range
With installation complete, check the shift
range while pedaling the bicycle.
The NuVinci N360 cannot be shifted (3)
completely through the ratio range while
stopped.
50-70% range is typically accessible,
with the remainder accessible with very
little pedal rotation (4).
1
VIDEOS ONLINE: Go to www.nuvinci.com/N360video
2
2
3
2
3
4
1
TM - READ ME FIRST
*B35-N360-02*
*B35-N360-02*
1
1
1/8” 3/32”
3
ü
To Next Page
Need help?
General
