2 31
Page 2
The amplifier is designed to be turned on and remain
on. The power button supplies power to the system.
Each zone can then be turned on or off independently.
This blue LED (light-emitting diode) will remain lit as
long as the power button is engaged. Note that once
the system is installed, it is designed to be left on.
These LEDs indicate the power status of each zone.
Once in standby mode, each zone has the ability to be
powered up or down independently.
POWER Button:
Stand By LED:
Zone Status LED:
E Series Amplifier Front
1
2
3
To Next Page
Loading...
