NuWave OXYPURE ZERO E2000 - Page 11

nuwavenow.com | 11
OPERATING THE OXYPURE
TIMER
HR
TURBO
HR
CLEAN DIRT
AIR
ODOR
NO
ODOR
STRONG
ODOR
SLEEP MODE
SLEEP MODE
Allows your Oxypure fan to still be active
while the LED lights are turned off. Adjust
the fan speed to your preference prior
turning on sleep mode.
1. Manually set FAN SPEED to desired
setting.
2. Press and hold FAN SPEED for 2
seconds again to activate SLEEP
MODE.
3. To turn off SLEEP MODE, press any
button.
NOTE: ULTIMATE CLEAN and TURBO will
work while the Oxypure is in SLEEP MODE.
TIMER
Allows you to choose the Oxypure’s
duration of operation from ½ hour, 1, 2, 4,
8, or 12 hours by settng a countdown timer
to shut off the Oxypure or end the current
function.
1. Press TIMER. The bar next to ½ hour
will be lit. After pressing timer six times,
all bars will be lit.
2. Press TIMER once more to turn the
TIMER off.
RESET FILTER
TURBO
Allows you to operate the Oxypure at the
highest fan speed 6 to clean the air for a
selected duration of time from ½ hour, 1,
or 2 hours. To add more time press Timer.
(Cannot run with Fan Speed).
1. Press TURBO to select and set the
duration of operation to ½ hour, 1,
or 2 hours. When the selected time
has finished, TURBO will shut off
automatically.
2. To exit TURBO mode, press TURBO
four times.
AIR QUALITY INDICATOR
The OxyPure will automatically measure
and display the current air quality in the
room. The colored bars around AIR will
illuminate, increasing and decreasing
according to air quality. See page 9 for
details on AIR/ODOR QUALITY.
ODOR QUALITY INDICATOR
The OxyPure will automatically measure
and display the current odor quality in the
room. The colored bars around ODOR
will illuminate, increasing and decreasing
according to odor quality. See page 9 for
details on AIR/ODOR QUALITY.
• After the filters are cleaned and
the indicator is reset, the first
green bar around AIR will be lit.
RESET FILTER
The CLEAN FILTER 2/3 light will illuminate
indicating that the Oxypure’s Bio-Guard
®
Filters 1 and 2 need to be cleaned. To reset
the indicator light after cleaning the filters,
1. Press and hold TIMER for 2 seconds,
until 2 beeps are heard and the
CLEAN FILTER 2/3 light turns off.
COLORS OF CLEAN FILTER 2/3 light:
• After about 3 months the green CLEAN
FILTER 2/3 light will turn Yellow
alerting you that the Bio-Guard
®
Filters
1 and 2 SHOULD BE CLEANED to
maintain optimal performance.
• After about 6 months the CLEAN
FILTER 2/3 light will turn Orange
indicating that the Bio-Guard
®
Filters 1
and 2 SHOULD BE CLEANED.
• After 12 months the CLEAN FILTER
2/3 light will turn Red indicating that
the Bio-Guard
®
Filters 1 and 2 MUST
BE CLEANED.
TO
MUTE BEEP SOUNDS (TURBO)
Press and hold TURBO for 4 seconds untill
3 beeps are heard. Repeat to unmute.