14 | nuwavenow.com
CLEANING & MAINTENANCE
Cleaning the Stainless Steel Pre-Filter
The Pre-Filter collects large particles and
will need to be cleaned at least once every
two months depending on use. The filter
can be cleaned using a vacuum with a
brush attachment or in warm soapy water.
1. Remove the Filter from slot .
2. Use a vacuum with a brush
attachment and vacuum up and down
then side to side.
3. Flip and repeat to vacuum the other
side of the Filter.
Cleaning the Ozone Emission Removal
Filter
1. Remove the Filter from slot .
2. Use a vacuum with a brush
attachment and vacuum up and down
then side to side.
3. Flip and repeat to vacuum the other
side of the Filter.
4. Repeat this process on the other side.
Cleaning the Bio-Guard
®
Filters 1 & 2
1. Remove the Filter from slots + .
2. Spray both sides of the Filter with a
mild degreaser or dish soap and set
aside for 2-3 minutes in the sink or a
cleaning tote caddy.
3. Lift Filter to drain excess cleaner.
Submerge the Filter in warm water.
Shake and flip to rinse.
4. Continue shaking and flipping in warm
water until the water is clear. (The
water may need to be changed several
times).
5. Drain all excess water by turning filter.
6. Allow the Filter to air dry completely
BEFORE placing it back into the
OxyPure (drying can take up to 12-24
hours).
1. Clean the Filter with warm soapy
water.
2. Rinse the Filter thoroughly until
the water is clear, and remove
any soap particles.
3. Allow the Filter to air dry
completely BEFORE placing it
back into the OxyPure (drying
can take up to 12-24 hours).
OR
Cleaning the Filter Sensor
The Filter Sensor is located on the back,
above the Filter Slot Cover.
1. Open the panel
(Sensor Cover).
2. Using a dry cotton
swab or small,
soft brush, gently
remove any dirt
or dust from the
Sensor.
3. For heavier
buildup on the
Sensor, wipe it
with a slightly wet
cotton swab.
4. Remove any
moisture with a dry
cotton swab.
• The Filter Sensor requires regular
cleaning (approx. every 3 months)
for the OxyPure to operate
efficiently.
• If your OxyPure is set up in an
area with high dust accumulation,
more frequent cleaning of the Filter
Sensor is needed.
• Do not use the cotton swab on any
part or area other than the Filter
Sensor.
Sensor Cover
1
2 3
4
To Next Page
Loading...
